SETTING UP YOUR DTV
Manual Scan
1. On the Channel menu page, select the third item MANUAL SCAN.
2. Press or to highlight the input column, then press numeric buttons to input the channel number. The channel frequency will be automatically showing on right side of the input column. 3. Press SEL button when the message �Add channel� and �press Enter to add channel� has shown.
4. If the ATSC signal is found and locked, the Status will show message �Add No. XX 8VSB channel successfully�. Then you can press EXIT to leave the menu page and watch the program, or go ahead scanning the other channels. 5. If the signal is not locked, the status will show �No Channel NO. �. You can scan the signal again or refer to the signal level bar �Signal� for aligning the direction of the antenna to get the signal. 6. When the signal is locked and the receiver is on the channel, you can enter into this page to check the signal level. Note: It�s suggested that you contact the antenna Installer when you have rouble of locking the signal.
Edit
1. On the Channel menu page, select the first item EDIT. 2. Press �� and buttons to highlight the channel�s BLOCK or FAV control column and press SEL to block channel or copy channel into the favorite channel list �F1�.
3. After the edit setting, press the RTN button, then will pop up a confirmation window: choose �NO� to cancel the edit change; choose �YES� to save the edit settings.
Note:
When the blocked channel has been selected, the program can not be showed, and you will get the message:" Channel is blocked� from TV
