PHILIPS 21PV385/07
Manual de Usuario

T6460EZ(EN)_UK.qx3

04.1.28

1:19 PM

Page 11

6. Manual recording
General information
Use 'Manual recording' to make a spontaneous recording (for example, a programme currently being shown). If you want to start and stop a recording manually, read the section 'Recording without automatic switch-off'. If you want to start a recording manually but have it stopped automatically, read the section 'Recording with automatic switch-off'. (e.g. not to record to the end of the tape)

Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows: 1.Find the tape position of the old recording 1. where you want to insert the new recording. 2.Look at the last minute of the old recording 2. (playback).
STILL 2 at the tape position where the new recording is to go and press REC I . 4.Now start recording as usual by pressing 4.
REC I

3.Press 3.

Recording without automatic switch-off
1.Insert a cassette. 1. 2.Use PROG P+ PROG P� or 0..9 to select the 2. programme number you want to record, for example, 'P01'. 3.To start recording, press REC I . 3. 4.Stop recording with STOP C-L . 4. The message 'PROTECTED CASSETTE CANNOT RECORD' appears briefly on the screen, then the cassette is ejected. A cassette without its security tab had been inserted. Cover the hole with adhesive tape or insert a new cassette.

on the remote control.
STOP C-L

5.Stop recording with 5.

.

Selecting the recording speed (SP or LP)
LP allows to double the recording duration on tape (for example six hours instead of three hours on an E180 cassette).

1.Press 1.

MENU

. The main menu will appear.
PLAY B-K

2.Select 'RECORD SETUP' using 2.
STOP C-L

or or

and confirm with .

FWD 1- B

.

3.Select 'RECORD SPEED' using 3.
STOP C-L

PLAY B-K

Recording with automatic switch-off (OTR One-Touch-Recording)
1.Insert a cassette. 1. 2.Use P+ P� or 0..9 to select the programme 2.
number you want to record.

SELECT K L CHOOSE B �RECORD SPEED [SP]

END=EXIT

3.Press REC I . 3. 4.Each time you press 4.

REC I

you will add 30 min-

utes to the recording time. 5.To stop recording, press STOP C-L . 5.

4.Select the required recording speed with 4.
FWD 1- B

.

Preventing accidental erasing
All cassettes (except rental and pre-recorded cassettes) have a security tab on the back of the cassette. To prevent recording over important recordings (erasing), you can remove this security tab. If you later decide to record on a protected cassette, simply cover the hole with adhesive tape or slide the tab to the right.

'SP' / 'LP' 'SP': Standard Play (normal recording speed) offers the usual first-class picture quality. 'LP': Long Play (half recording speed, double recording time). 6 hours can be recorded on a 3-hour cassette (E180) with a somewhat reduced picture quality.

5.To end, press 5.

STATUS/EXIT

.

11

EN