No hay comentarios de productos.
2.
INSTALLING YOUR TV-VIDEO COMBI
Allocating a decoder
Some TV stations will send coded TV channels, that you can only watch when you use a decoder. You can connect such a decoder (descrambler) to your TV-VIDEO Combi. With the following function, the connected decoder will automatically be activated for the TV programme you want to watch.
a Choose the TV channel on which you wish to use the
Initial installation
a Open up the battery compartment of your remote control
and place the batteries in it as shown in the picture.
decoder with the P pAB button on the TV-VIDEO Combi or the number buttons 0-9 on the remote control.
b Close the battery compartment. c If you have connected the aerial to the TV-VIDEO Combi, b Press the MENU button on the remote control. The main
menu will appear.
c Select the line �Installation� with the P rB or
AP q
press the OK button. �Automatic TV channel search� starts. This picture will appear on the screen:
buton and confirm with the
SqC
button.
d Select the line �Manual store� with the P rB or
AP q
button and confirm with the
SqC
button.
e Select the line �Decoder� with the P rB or
AP q
Searching... CHANNELS FOUND: MANUAL STORE
button.
//////,,,,,,,,,,,,,,,,,,,,,
Channel/Frequency FREQU. Search 125 Fine tuning (,,,,,,n=,,,,,,$ Name edit xxx Programme number 01 Decoder OFF
Wait until all TV channels have been found. This can take several minutes. D If you have connected a decoder, you must install it as described in the next section. D If you have connected a satellite receiver, please read the section �satellite receiver�.
ã Exit: « press MENU
f Select function �ON� with the DSr or SqC
button. When you select �OFF�, the function will be switched off.
g Confirm with the OK button. h To end, press the MENU button.
Your decoder has now been allocated to this TV channel.
i Press the MENU button again.
5
