SYSTEM PROGRAMMING STEPS
Step 10 - Press the NEXT button once.
Three LEDs illuminate: ENTER IR, PROGRAM and SOURCE 2.
The SEQUENCE LED blinks.
Step 11 - Press each Function Key/Button that corresponds to each step of the Sequence you wish to program for Source Two in the same order they will occur. Note: To insert delays, use the Volume � or + buttons. (Vol � = .5 sec., Vol + = 1 sec.) Sequences can have up to 64 steps (commands and/or delays).
The ENTER IR LED blinks once when the Function Key/Button command is received.
Three LEDs illuminate: ENTER IR, PROGRAM and SOURCE 2.
The SEQUENCE LED blinks.
Step 12 - You have now completed the programming for Source Two. Press the NEXT button once.
Three LEDs illuminate: ENTER IR, PROGRAM, and SOURCE 3.
